LED Load Resistor Kit - CERAMIC by Putco.
*** Recommended for 1999 and earlier vehicle applications.
If installing LED bulbs in your car or truck causes your blinkers to hyper-flash (blink very fast) or cause other electrical problems, this Load Resistor Kit should resolve the problem. Since LED bulbs draw much less current then standard incandescent bulbs your electrical computer system may think that your bulbs are not working. This is a 6 Ohm 50 Watt resistor that needs to be installed in-line with your tail/blinker lights. Using the included splice taps, one wire is is connected to ground and the other to the lamp hot wire. Splice taps allow for easy installation without cutting turn signal wires.
*** ONE Load Resistor Kit is required for EACH tail/blinker light.
*** Caution - Load Resistor gets extremely hot and needs to be installed correctly. The flat surface of the ceramic resistor needs to make a good secure contact on a clean flat metal surface on your car or truck. This will act as a heat sink which should keep the load resistor cooler. Keep this load resistor away from oil, making contact with skin, plastic, wires and combustible gases and material. UAA is NOT responsible for damage caused to persons or property with installation of the Load Resistor Kit.
Truck Cars Putco Replacement LED Brake Taillamp Bulbs 230004A Acura Buick BMW Cadillac Chevrolet Chevy Chrysler Dodge Ford Geo Honda Hummer Hyundai Infiniti Isuzu Kia Lexus Lincoln Mazda Mercedes Mercury Mitsubishi Nissan Oldsmobile Olds Plymouth Pontiac Saturn Subaru Suzuki Toyota CTGLED CTGEA CTCLED CTCEA 1980 1981 1982 1983 1984 1985 1986 1987 1988 1989 1990 1991 1992 1993 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 
|
