1996-98 Chevrolet/GMC Silverado / Sierra 3500 4WD 5 - 7 in. Front / 5 in. Rear. 1996 1997 1998 1999 Truck SuperLift 6 Inch Lift Kit K2749 Chevy Chevrolet GMC CTGLKS CTGSS
This Kit uses 5 inch BLOCKS to raise the rear.
*** Vehicles with AutoTrac require replacement Front Driveshaft - See Related Products below.
*** U-Bolts in kit will NOT fit Dually trucks - Custom U-Bolts required.
*** Trucks with 2 piece rear driveshaft will require a custom made replacement driveshaft, I piece driveshaft will work with part# 3223 kit. The front differential assembly is also lowered to keep CV axle angles in check. This is accomplished by using two, one-piece tubular cross members that span from frame rail-to-frame rail. Superlift#39s new control arm brackets connect to these cross-members along with "kicker" braces to form an exceptionally strong assembly. Steering linkage geometry is addressed by relocating the factory centerlink, which keeps the tie rods in phase with the lower control arms. Two greasable stabilizing links regulate centerlink movement and reduce the load and stress transmitted to the pitman and idler arms.
Features
Retains factory ride quality, steering geometry, and CV axle angles Front track width not increased Full-width differential / control arm crossmembers provide lateral rigidity Load bearing bracketry made of 0.25" thick plate steel or DOM tubing Cross-member kicker braces add strength front-to-rear Dual centerlink stabilizing links make steering more responsive and extend pitman / idler arm life Front differential housing does not require trimming Front/Rear Superide shocks with yellow boots included Recommended Tire Size: 35" x 12.50" tire on 8" to 9" wide wheel with 4.5" to 5.5" back spacing.
Foot Notes:
1- 1997-2000 models with Autotrac require dual cardan driveshaft, See Related Products Below. Non-Autotrac models may also need driveshaft if regularly driven in 4WD over 35 MPH.
7-With single exhaust, a new, reformed section of exhaust crossover pipe is required to clear front driveshaft.
27- Special puller tool is recommended to load/unload torsion bars.
43- Extended Cab and CrewCab trucks will require part #3223 transfer case support bracket.
81- Cannot re-use factory steering stabilizer, if equipped. See Related Products below for replacement unit.
Everything
is On Sale!! Weekend Special
